Procedure for Soft Curl Permanent.

Implement and Supplies material

Thio cream relaxer Thio curl booster Preneutralzing conditioner (optional) Thio neutralizer Protective base cream Acid balanced shampoo

Conditioner Plastic or glass bowl Applicator brush Applicator bottles Shampoo cape Neutralizing bib Disposable gloves Roll cotton

Towel Plastic clips Styling comb Plastic tail comb Perm tools End papers Spray bottle timer

 

Preparation.

1.wash your hands.

2. Perform client consultation, including a analysis of the client’s hair and scsaalp. Note results in the client record.

3.Have the client change into a gown and remove eyeglasses, earning, and necklace. Drape the client with a shampoo cape and two towels.

Procedure.

1. Applying virgin hydroxide relaxer

2. After rising the hair, part it into mine panel. Use the length of the rod to measure the width of the panel.

3. Wear gloves on both hands and begin wrapping at the most resistant area. Apply and distribute the thio curl booster to each panel as you wrap the hair. Make a horizontal paring the same size as the rod. Hold the hair at a 90-degree angle to the head. Using two end papers, roll the hair down to the scalp and position the rod half off base. Optional: insert roller picks to stabilize the rods and eliminate any tension by the band.

4.Continue wrapping the remainder of the first panel using the same technique

5. Continue wrapping the remaining eight panel in numerical order using the same technique.

6. place cotton around the hairline and neck and apply thio curl booster to all the curls until they are completely saturated.

7.If a plastic cap is used, punch a few holes in the cap and cover all the hair completely. Do not allow the plastics cap to touch the client skin.

8. Check cotton and towels. If they are saturated with solution, replace them.

9.Process according to manufacture directions. Processing time will vary according to the strength of the products, the hair type and condition, and desired results. Processing usually take less than 20 minutes at room temperature.

10.Check for proper curl development

11.When processing is completed, rinse the hair thoroughly, for at least five minutes. Then towel-plot the hair on each tool to remove excess moisture.

12.Apply the neutralizer slowly and careful to the hair on each toll. Avoid splashing and dripping. Make sure each rod its completely saturated.

13.Set a timer and neutralize according to the manufacturer’s directions. Remove the rods, distribute the remaining neutralize through the ends of the hair and rinse thoroughly.

1.Style the hair as desired.